CROSSDRAFT BOOTHS
The Crossdraft booth intakes fresh air through filters in the product doors and door side panels. The clean filtered air is drawn through the booth and exhausted through a filter system at the other end. This type of spray booth makes efficient use of shop space and is available in solid back, drive through, and reverse flow designs. Reverse flow booths intake air through filters in the back wall. The solid doors are at the exhaust end of the booth. This provides cleaner intake filtration and better control of shop dust.
SEMI DOWNDRAFT BOOTHS
The Semi Downdraft / Crossdraft booth intakes fresh air from the cleaner upper levels of the shop, through a bank of filters in the ceiling near the product doors. The filtered air is drawn down across the length of the booth, through a filtered exhaust system at the back. The booth is available in solid back, drive through, and reverse flow designs.
SIDE DOWNDRAFT BOOTHS
The Side Downdraft booth offers most of the full downdraft booth benefits without an expensive pit. Fresh air is brought in from the clean upper levels of the shop, through filter banks in the ceiling of the booth. The clean filtered air is drawn down and away from the product through exhaust filters at floor level along both sides of the booth. The over spray is pulled away from the product and away from the painters. This booth is equipped with an air supply plenum and is available in both solid back and drive through designs.
DOWNDRAFT BOOTHS
The Downdraft booth offers most efficient airflow. Fresh air is brought in from the clean upper levels of the shop, through filter banks in the ceiling of the booth. The clean filtered air is drawn down and around the product through exhaust filters in the pit in the floor of the booth. The over spray is pulled around the product and away from the painters. This booth is equipped with an air supply plenum and is available in both solid back and drive through designs.
AIR MAKE UP UNITS
All booths can be equipped with air replacement units that control inside air pressure, temperature, and cure cycles to meet your requirements. A variety of options are available to meet your specific requirements.
LIGHTING FEATURES
Bright full booth illumination is provided by four tube, 48"-32 watt fluorescent light fixtures in the angled ceiling panels and side walls. Each is mounted behind a clear tempered safety glass and sealed with a trimlock gasket. All fixtures are UL listed and approved for their intended use and placement. The light tubes are not furnished with the fixtures.
CONSTRUCTION FEATURES AND QUALITY STANDARDS
All booth and plenum sections are made with 18 gauge galvanized steel. All product and personnel doors are pre-hung in heavy gauge galvanized steel frames for easy installation. Brixon latches are provided for each door opening. All exhaust fan units are equipped with TEFC motors and sized for more than adequate air flow movement to meet all quality code standards. All hardware, filters and sealants needed for the booth installation are included.